CLAMP UNIT

     Over conventional 3-platen machine

• Increased performance - 50% increase in clamp speed and 80% reduction in tonnage build time

• Greater flexibility - Longer stroke & daylight with large tie bar spacing

• Reduced setup time - No ram spacers to change - Easy access to ejector mechanism

• Lower operating cost- Reduced power consumption - 48% less hydraulic oil

• Reduced footprint by an average of 15%

• Clamp speeds upto 900 mm/sec. minimize the mould open and close time

• Fully supported strain rods that guide the moving platen. This eliminates bushing wear. Maintains platen parallelism

• Closed loop mould protect for sensitive control of mould safety.

• Rigidity in clamping due to shorter active span of tie bar and direct acting ram building tonnage in the center of the platen.

• Shorter tonnage build stroke increases seal life

• Substantial reduction in horse power due to smaller volume of oil required to build tonnage.

Long guided length of the moving platen
ensures parallelism and stability even with heavy molds

SPLIT NUTS

Designed so the force is evenly distributed across the tie bar grooves and proximity switches verify correct closure position prior to lock

Exclusive designed hose carrier ensures
that all hoses are kept from bending or
crimping in a safe, smooth moving assembly